HES Cabling System
Installation Manual for Category 6E Shielded Tool-Less Keystone Jack
HCS P/N J6E-00863 - Universal Wiring - S/STP Cable
1
Remove 5 cm of the cable jacket.
2
Fold back the braid shield.
3
Carefully remove all foil shields.
3
Hold the wiring block with the colored side up and insert the pairs into place as shown below.
4
Insert the wires into the correct colored slots.
5
Cut the wires flush with a sharp tool.
6
Slide the wiring block into the the jack housing with the colored side down and
push gently with your thumb. Note the guide and the IDC contacts.
7
Fold up the side caps.
8
Press the side caps firmly until they click and
make sure both caps are securely closed.
9
Slide the metal shield over the
jack. Note the correct orientation.
10
Close the metal shield.
11
Make sure the two grounding belts are
inserted into the two slots.
12
Pull the grounding belts with a
suitable pliers and fold them.
13
Wrap the shield and press
tightly both grounding belts.
Note: Avoid damaging the cable when using the pliers and make sure the braid shield is in good contact with the keystone jack shield.
Form HC6SSTP-TLKSJ-1 Rev 01/05 dated 26 July 2005
www.hescs.com
