Mar. 2006
TPM-W Operator’s Manual
4
Low tire pressure
(Highest priority)
Slow air leak
High tire pressure
High temperature
Low Battery
No Sensor Signal
(Lowest priority)
Mar. 2006
TPM-W Operator’s Manual
5
3.4 Display Control
•
A warning will continue to be displayed until the cause of the warning
is corrected.
•
When multiple warnings occurred, the higher priority warning will be
displayed first.
•
Pressing the Control Button for 3 seconds will clear the warning
display.
•
If the abnormal situation persists, however, warnings will be
displayed again even after the display was cleared.
•
The system continues to monitor the tires even after the vehicle is
turned off. When the vehicle’s power is turned back on, the current
tire information is displayed.
4. Warning Threshold Set Up
The user can adjust the warning threshold for tire pressure and
temperature, as follows:
•
Press and hold down the Setup Button located on the side of the
Display. While holding down the Setup Button, turn the vehicle’s
power on. After 3 seconds the system enters the Warning Setup
Mode. Release the Setup Button.
•
The first screen is for setting up the Low Pressure warning
threshold. Pressing the Setup Button again brings up the next
screen (High Pressure).
•
While in a setup screen, the Control Button on the front panel is
used to change the threshold setting. Pressing and holding down
the Control Button advances the setting rapidly.
•
While in a setup screen, pressing the Setup Button exits the
setup. While in the last screen (High Temperature), pressing the
Setup Button exits the Warning Setup Mode and saves the new
settings for all screens.
•
Turning vehicle’s power off before exiting the last screen always
cancels the setup.
