4 / 16
3. Securely close the battery compartment cover by sliding it up until it snaps into place.
4. Place the handset on the base as shown.
5. Make sure that the
status
LED lights. If the LED doesn’t light, check to see that the AC adapter is
plugged in and that the handset makes good contact with the base charging contacts.
Note Use only the Uniden Battery (
???
) supplied with your phone. Replacement batteries are also available
through the Uniden Parts Department.
Battery use time (per charge)
From fully charged
l
Four and hal f hours continuous use.
l
Ten days when the handset is in the standby mode.
When the battery charge becomes low
When the battery pack is very low and needs to be charged, the phone is programmed to eliminate functions
in other to save power. If the phone is not in use, “ Low Battery” flashes and none of the keys will operate. If
the phone is in use, “Low Battery” flashes and the handset beeps. Complete your conversation as quickly as
possible and return the handset to the base unit for charging.
Note The built-in memory backup can hold numbers and names stored in the memory even if the battery
pack is completely discharged.
Cleaning the battery contacts
To maintain a good charge, it is important to clean the battery contacts on the handset and base un it with a
dry cloth or a pencil eraser about once a month.
Do net use any liquids or solvents.
Registration
The digital security code is an identification code used to connect the handset and the base unit.
In the rare situation that you suspect another cordless telephone is using the same security code, you can
change the code.
1. Remove the handset from the base unit.
2. Press and [flash] + handset No.(1~7).
3. Place the handset on the base unit.
When registration is completed, confirm tone will sound.
Register As
Handset #
Low Battery
