Operating the Data Recorder
32
A3169-8.0
HBM: public
CX22B / CX22B-W
S
The CX22B‒W and PC are connected directly via an
Ethernet cable.
S
The CX22B‒W Data Recorder is connected to an Eth
ernet network (the network configuration is usually
assigned automatically via DHCP,
D
ynamic
H
ost
C
on
figuration
P
rotocol).
For a detailed description, see
Section 6.2.2, Page
.
S
The CX22B‒W Data Recorder is connected via
WLAN (ad‐hoc to a PC or hotspot integration into lo
cal area network-LAN).
Important
Wait approx. 1 minute after switching on the CX22B‒W
before setting up a connection so that the boot process is
complete and the module is ready. Otherwise you may
receive an error message that the device could not be
found.
To make it easier to set up a connection when the
CX22B‒W settings are unknown, use the HBM program
HBM Device Scan
, which is part of the system software
and included in the package as a DVD. It is also available
to download from (www.hbm.com -> Support -> Down
loads).
You can also set up a direct remote desktop connection
(standard program of the Windows operating system).
You need to know the IP address of the device to do this.
The device is delivered with factory settings and DHCP.
So you must use the "HBM Device Scan" software for
the initial start-up at least, or work with the direct periph
erals.