6 Calibration Verification
6.1
Introduction
The Verification process performs all verifications that have been done at the
factory.
The Verification process contains the following tests depending on the selected
device:
l
DC Gain
l
AC Coupling
l
Bandwidth
l
Noise
l
CMRR (Common Mode Rejection Ratio)
l
DC Output
l
Output Noise
l
Output Res.
Note
The calibration and verification tests depend on the installed and selected
board. Therefore the windows displayed may differ from the illustrations used
in this manual.
Note
The timebase accuracy will not be verified!
CAUTION
Before starting a calibration or verification, it is recommended that the
ISOBE5600 system and the calibration standards run at least one hour to
achieve the best test specifications.
ISOBE5600
82
I2716-4.0 en
