9.2
Recording
Since many of the features that are described here are controlled from within
the Perception software, it is advised to read this section in combination with
the corresponding sections in the Perception manual.
The GEN3i/Perception combination provides the following acquisition controls:
●
RUN
The run command starts recording of data. Now the recorder(s)
record(s) data until a stop command is issued. This stop command can be
manually or triggered (when in sweep storage mode).
●
STOP
To stop or abort a recording.
●
PAUSE
This mode has two options:
1
When no recording is active, it places the recorder in the pause or
stand
-
by mode. Although the recorder is digitizing, no data is stored in
memory or disk. This is useful for monitoring purposes.
2
When a recording is active, it places the recorder in a hold mode.
Although the recorder is digitizing, no data is stored in memory or disk.
At the point when RUN is selected, the current recording continues.
When STOP is selected, the recording is finished.
These recording controls are combined with the various storage modes.
GEN3i
132
I3763-3.1 en HBM: public
