EXRLCPU Data Controller
Connections
1. Connect the 1-EXR-PWR-PT-2 power cable from the
INPUT connector to a 8–36 V
DC
power supply.
NOTE
If a switch is not connected to the red and black wires of the
remote switch cable, make sure the wires are fully insulated from
each other or solidly connected to each other to prevent
accidentally turning the power off. If the wires are connected to
each other and there is any chance of magnetic induction, do not
coil the cable in a loop.
2. Connect the 1-KAB2106 Ethernet cable from the HOST
connector to the host PC. The host PC network settings
must be compatible with the main processor default
IP address 192.168.100.101.
3. Connect desired transducers to GPS and CAN ports
using appropriate cables.
4. Wait at least five seconds after supplying power to the
unit.
5. Press and release the power button. The green LED
turns on. Wait about 15 seconds for the unit to boot up.
6. Open a web browser and navigate to the default IP
address 192.168.100.101. If the main processor is on a
network with a DHCP server, use the HBM Device
Manager (on the included USB drive) or contact your IT
administrator to find out the IP address. If presented with
a certificate warning, choose to proceed. The main
processor web interface is displayed.
In the box
n
EXRLCPU and connector dust caps
n
2.5mm ball hex driver (SO-123-1003006)
n
Four (4) standoffs (SO-257-1003660) and four (4) flat head screws
n
Power cable (1-EXR-PWR-PT-2), Ethernet cable
(1-KAB2106-2) and two (2) CAN male/pigtail cables
(1-SAC-TRAN-MP-2-2)
n
eDAQXR/eDAQXR-lite Safety instructions
n
eDAQXR-lite Quick Start Guide
n
USB flash drive
POWER
(green)
Off
Unit is off.
On
Unit is on and ready. Preceding sequence of
LEDs flashing indicates the system is loaded.
4 Hz
Unit is shutting down, rebooting or updating
firmware.
2 Hz
Unit is in locate mode.
RUN
(yellow)
Off
No test run is in progress.
On
After power supply is disconnected, backup
capacitors hold a charge.
Opening the CPU before
the LED is off may result in damage.
RUN
(yellow)
0.5 Hz
Test Setup task running.
1 Hz
Backup capacitors are charging from the connected
power supply while CPU is switched off.
1 Hz
Remote control is enabled, but no Test run is
in progress (CPU on, solid green LED).
8 Hz
Test run is in progress.
ERROR
(red)
Off
No error.
On
Unit error. Purge System logs to turn off LED.
1 Hz
Low storage (less than 2 MB remains).
EXRLCPU Status LEDs
EXRLCPU Quick Start Guide
