Wire and Flex level sensor manual 04
October 2021 HBproducts.dk 15
Here you set the parame-
ters for the alarm func-
tion.
Only available for sensors
without cable
Here you can adjust
parameters for the
valve control
Advanced settings
Here you make the advanced settings of the sensor
Alarm relay function
: Here, the relay function is indicated, depending upon
the instructions –
NO or NC (normally open/normally closed). Here the signal
can be changed from alarm on below or above the alarm setpoint
Output direction:
Here you select either LP
-
mode (low pressure control) or HP
-
mode (high pressure control). In LP
-
mode, the container is filled so that the
level is maintained, and in HP
-
mode the container is emptied so that the level
is maintained. LP
-
mode = 4
-
20 mA. HP
-
mode = 20
-
4 mA.
Set mA or digital 2 output
Select the sensor output digital or analog
Digital 2 alarm in %:
set the alarm setpoint
Digital Hysteresis in %: %
: Indicates the deviation required before the alarm is
deactivated, following activation of the alarm. Alarm hysteresis in percent of
the probes calibrated span 0 and 100%.
Alarm setting is as well in % of the probes calibrated span 0 and 100%.
E.g. alarm setting = 80%, Alarm hysteresis = 25%
Set LED indication:
Determines the function LED lighting has.
