22
7.3 Effective Lengths
You must enter the gauge
l
w
of the plug
tool that you are using in the “WL” menu option.
For the gauges of HAZET plug tools, please refer to the
relevant tool manual.
ATTENTION!
If the programmed effective
length does not match the effective length of
the plug tool used, there will be a discrepancy
between the torque value shown on the display
and that applied to the screw joint.
1. In order to set the effective length, you will need to
switch to the menu using and preferably select the
“WL” menu option using .
2. After pressing in the “WL” menu option, you can
set the effective lengths of the used plug tools using
or .
3. Confirm the value you have input using .
7 .4 Direction of rotation
You will need to use the “+ / -” menu option to set the
direction of rotation in which you want to operate the
wrench by choosing right (+) or left (-).
1. After pressing in the “+ / -” menu option, you
can set the direction of rotation using or .
2. Confirm this setting by pressing .
8 . Programming
The last programmed settings are displayed when the
wrench is switched on. The individual modes are dis-
played as follows:
• Torque mode,
• Rotation angle mode,
Check that the display shows the mode in which you
want to work.
Carefully check that all programmed setting values are
correct. Once all settings for the next screwing process
which you want to perform are correct, confirm the
entries using the button. The symbol appears and
the torque wrench is ready to use.
Note!
If you do not confirm your settings/
changes by pressing
, the torque wrench
with built-in angle gauge is not ready for use.
No display will appear when you switch it on.
8 .1 Torque:
The “Nm / °” menu option enables you to perform the
programming for the screw tightening process using
“Torque”.
1. By selecting the “Nm / °” menu option, after confirm-
ing using , you can set the “Target value” value
for torque using
. The setting changes in 1 Nm
steps.
2. After confirming the value using , you will need to
set the value for the rotation angle to 0°using .
3. After confirming using , you will have defined the
torque target value.
ATTENTION!
“Torque” mode is only active when
the rotation angle is set to 0°.
3
Design and Function
Summary of Contents for 7292-eTAC
Page 27: ...Notizen Notes 27 ...
