Hayward Phantom Turbo 6000, Owner'S Manual

Page: 15 / 46

C Clleeaan niin ng g tth hee IIn n--LLiin nee FFiilltteerrss
1 1.. The Hose In-Line filter (Part Q) is located by the Wall Quick
Connect (Part K).
2 2.. To remove the screen inside the In-Line Filter, unscrew
the cap of the In-Line Filter and remove the screen.
3 3.. Remove the debris from the screen and rinse. IIm mp po orrtta an ntt:: If
the screen frequently becomes plugged, the filtration
system is not performing properly or there is another
plumbing problem.
4 4.. Place the open end of the screen into the outlet end of the
In-Line Filter and screw the cap back on.
IIm mp po orrtta an ntt:: Make
sure the O-Ring is in place and properly seated.
C Caau uttiioon n -- R Riisskk ooff E Eq qu uiip pm meen ntt D Daam maag gee
N Ne evve err o op pe erra atte e tth he e cclle ea an ne err w wiitth ho ou utt tth he e ssccrre ee en n iin n p plla acce e..
Operating the cleaner without the screen will damage the
cleaner’s internal mechanism.
5 5..
Inlet Manifold filter screen stays in manifold inlet when hose
is removed for storage.
6 6.. If there is debris in the filter it can be removed for cleaning
by grasping the bar and gently pulling while twisting.
7 7.. Rinse to ensure that all debris and sand is removed from
the inlet filter screen.
8 8.. Before replacing the manifold, check that there is no debris
visible inside of manifold inlet. If sand or debris can be seen,
gently rinse out manifold using a water hose with inlet
pointed down.
15
Use Only Genuine Hayward Replacement Parts.
14
Use Only Genuine Hayward Replacement Parts.
S Sw weeeep p H Hoossee
• Sweep Hose Wear Rollers will experience wear when
operating in a plastered or concrete pool.
• When the Wear Rollers wear-down to the outer groove
(Wear Line) replace the Wear Rollers (P/N AX5006A).
• Check the Sweep Hose for holes
(Replace if necessary with P/N: AX5000RSHA).
Some parts will wear with normal use. To ensure the high quality
performance, insist on
G Ge en nu uiin ne e H Ha ayyw wa arrd d rre ep plla acce em me en ntt p pa arrttss
((u ussiin ng g n no on n--H Ha ayyw wa arrd d rre ep plla acce em me en ntt p pa arrttss w wiillll V Vo oiid d tth he e
P Ph ha an ntto om m T Tu urrb bo o C Clle ea an ne err’’ss W Wa arrrra an nttyy)).. The following parts are
user replaceable and subject to normal wear and tear.
1 1.. S Sw we ee ep p H Ho osse e:: If a hole forms in the Sweep Hose, it should
be replaced. Unscrew the metal mender nut from the hose
and pull the Sweep Hose (Sweep Hose Replacement Part
Number: AX5000RSHA) off the Cleaner Connector. Attach a
new Sweep Hose to the Cleaner Connector.
2 2.. L La arrg ge e C Ca ap pa acciittyy D De eb brriiss B Ba ag g w wiitth h F Fllo oa att:: The Debris Bag
should be replaced if it is torn (Replacement Part Number:
AX6000BA).
3 3.. S Sw wiivve ellss:: If a swivel ceases to turn easily or leaks while
the cleaner is running, it should be replaced.
S Sttoorriin ng g tth hee P Ph haan nttoom m C Clleeaan neerr
1 1.. T Tu urrn n tth he e B Bo oo osstte err P Pu um mp p O OF FF F
and set the timer so the
Booster Pump will not turn on while the Phantom cleaner is
out of the pool (
N
Ne evve err operate the Booster Pump without
the cleaner connected).
2 2..
Disconnect Wall Quick Connect from the Universal Wall
Fitting. The Universal Wall Fitting may be left in place.
3 3.. The cleaner is constructed of the finest materials available,
however we recommend that when the Phantom cleaner is
removed from the pool, it should be stored flat on its wheels
in a shaded area to protect the unit form excessive exposure
to sunlight.
4 4.. Store the Sweep Hose and the Hose Cleaner End Assembly
(Part S) straight and flat,
n no ott cco oiille ed d . The Rigid Hose Pipe
Sections may be folded on one another, so that the short
hoses in-between are bent. If possible, store the hoses in
the shade.
W Wiin ntteerriizziin ng g tth hee C Clleeaan neerr
When closing your pool for the winter completely drain the water
from the Phantom Cleaner (by slowing rotating it in all directions)
and Hoses. Store the Phantom Cleaner indoors to prevent
freezing of the inner mechanisms.
P Peerriiood diicc FFrreeeezziin ng g C Coon nd diittiioon nss
If you are in an area subject to periodic freezing conditions, but
pool equipment is kept in operation, it is very important that the
filtration system and Phantom cleaner be in operation during
times when hard freezing occurs (normally between 3 AM and
7AM). Running the Phantom cleaner at this time will ensure
against damaging the Cleaner and may prevent freezing the
pool water.
M Maaiin ntteen naan nccee S Sttoorriin ng g tth hee P Ph haan nttoom m T Tu urrb boo C Clleeaan neerr
R Re em mo ovviin ng g tth he e P Ph ha an ntto om m T Tu urrb bo o C Clle ea an ne err F Frro om m tth he e P Po oo oll
W Waarrn niin ng g – – R Riisskk ooff IIn njju urryy
The Booster Pump and Filtration Pump must be O OF FF F when
connecting or disconnecting cleaner or hose.
1 1.. T Tu urrn n tth he e B Bo oo osstte err P Pu um mp p a an nd d F Fiillttrra attiio on n P Pu um mp p O OF FF F.. If
you will not be replacing the cleaner before the next Booster
Pump timer cycle, turn the Booster Pump Timer
O OF FF F.. N Ne evve err
run the Booster Pump without the cleaner connected.
F Fa aiillu urre e tto o d do o sso o cca an n cca au usse e sse erriio ou uss iin njju urryy..
C Caau uttiioon n -- R Riisskk ooff E Eq qu uiip pm meen ntt D Daam maag gee
N Ne evve err run the Booster Pump without the Cleaner connected.
Doing so will damage the pump’s motor and void the Booster
Pump’s warranty.
2 2..
From the pool deck looking down push the Wall Quick
Connect into the Universal Wall Fitting and turn it to the right
(clockwise).
3 3..
Pull the Wall Quick Connect out of the Universal Wall Fitting.
4 4..
Grab the cleaner by the wing, and remove from the pool.
5 5.. Disconnect the Cleaner Connector from the Phantom
Cleaner.
6 6.. Lay the Cleaner End of the Pressure Hose and the Sweep
Hose flat and straight.
IIm mp po orrtta an ntt:: Always store the Cleaner End of the Pressure Hose
and the Sweep Hose straight, n no ott cco oiille ed d . The cleaner may not
operate properly with these hoses bent.
E Em mp pttyyiin ng g tth hee D Deeb brriiss B Baag g
• Empty the Debris Bag regularly. Do not continue to operate
the Phantom when the bag is full.
1 1.. Hold Bag over trashcan or wherever debris is to be placed.
2 2.. Slide Float Closure off of bag.
3 3.. Hold open edges apart and shake debris from bag.
4 4.. Slide Float Closure onto bag.
• S Sa an nd d ((d de en nsse e d de eb brriiss)):: A Allw wa ayyss e em mp pttyy tth he e P Ph ha an ntto om m
D De eb brriiss B Ba ag g w wh he en n tth he erre e iiss tto oo o m mu ucch h ssa an nd d ((o orr h he ea avvyy
d
de eb brriiss)).. If the Cleaner cannot climb to the surface in TOP
or AUTO mode OR the Bag “droops” over the hose ttu urrn n tth he e
B Bo oo osstte err P Pu um mp p O OF FF F a an nd d e em mp pttyy tth he e D De eb brriiss B Ba ag g..
• When the bag is full of leaves or other debris, the debris may
trap air in the bag while skimming the surface. If the trapped
air prevents the cleaner from descending to the pool bottom,
empty the Debris Bag.
D DO O N NO OT T o op pe erra atte e tth he e P Ph ha an ntto om m iiff iitt rru un nss o on n iittss ssiid de e o orr
u up pssiid de e--d do ow wn n..
IIn n--L Liin ne e F Fiilltte err
W We ea arr R Ro olllle err
Wear Line
(outer groove)
IIn n--L Liin ne e F Fiilltte err
Screen
M Ma an niiffo olld d F Fiilltte err