4.2.
Usage of wire controller
4.2.1
Turn ON/OFF the unit
4.2.2
Setting temperature
When the unit is off, press the key“ ”0.5s to turned on the unit;
When the unit is on, press the key“ ”0.5s to show down the unit.
Standinterfaceby Running
interface
Press“ ”0.5s
Press“ ”0.5s
9
Heating/ Cooling
actual water Temp.
4. USAGE
In the running interface
，
press“ ”or“ ”then the current mode target-temperature flashes,
then press“ ”to increase the temp.value, or press“ ”to decrease it. Press“ ”will not
save setting parameter but back to the main interface; Attention
：
If there is no operation for
5s
，
system would remember parameter setting and back to the main interface. In the main
interface
，
press“ ”for 2s you can see the outlet temp.The parameter is then flashed and the
display is back to the main interface after 10s.
Press“ ”
Press“ ”
Press“ ”
Press“ ”2s
or “ ”
Heating/ Cooling
Target Temp.
Heating/ Cooling
Target Temp.
Outlet Temp.
System will save user's
setting and return back
to main interface if there
is no operation in 5s.
Summary of Contents for HP50CL
Page 2: ......
Page 15: ...4 4 Malfunction Table The common failure cause and solution 4 USAGE 12 ...
Page 24: ......
