Description
The HLWALLMOUNT is a remote touchscreen terminal that wires directly to the OmniLogic pool
automation controller. It is designed to fasten to a wall giving the user convenient access for
monitoring and controlling their pool. Up to two HLWALLMOUNTs can be installed and connected
to the OmniLogic. After installation, the OmniLogic will detect the new HLWALLMOUNT(s) and
automatically configure itself to utilize the new terminal(s).
Compatibility
The HLWALLMOUNT is compatible with all OmniLogic pool controls.
Before You Begin
Included:
•
HLWALLMOUNT Remote Terminal
What you'll need:
•
mounting screws/anchors
•
an appropriate length of 4 conductor, 20 - 24AWG twisted pair wire (CAT3 or better pre-
ferred but not mandatory) for connecting the HLWALLMOUNT to the OmniLogic
•
wirecutter/wirestripper
•
tools for mounting, small flathead screwdriver for screw terminals
The HLWALLMOUNT must be mounted indoors or in a weather protected area (rain should never
be in contact with the touchscreen).
When considering a potential mounting location, survey the wiring route from the OmniLogic to
the HLWALLMOUNT. Ensure that you can successfully run an uninterrupted length of 4 conduc-
tor wire. Although various types of wire can be used, 4 conductor, solid 22AWG phone cable
is recommended. Refer to the table below for limitations on wire run lengths. When selecting
a location, note that the connecting the OmniLogic to the HLWALLMOUNT must not exceed the
recommended lengths shown in the chart below.
Up to two HLWALLMOUNTs can be wired to the OmniLogic. If wired in parallel, both units can
be wired up to the maximum distance shown below. If daisy chained, the furthest unit can not
exceed the maximum distance shown below.
20 AWG
22AWG
24AWG
Maximum Distance
450ft / 140m
285ft / 85m
180ft / 55m
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
2
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
2
