When the cleaning cycle is completed and the cleaner is either in
sleep mode (Start/Stop button light is solid blue) or in stand-by
mode (Start/Stop button light is blinking green), The
Aquashark
Series can be easily removed from the pool by using the handle
on the cleaner.
1.
Remove the cleaner by pulling it out of the water using the
handle on the cleaner.
2. Allow the cleaner to drain on the pool deck before removing
the filter cartridge for cleaning.
REMOVING THE CLEANER FROM THE POOL
30 s.
1.
Place the
Aquashark
on its side.
2.
Release the bottom lid latches and remove the bottom lid
assembly.
3.
Pull out the filter cartridge. Your cartridge is a three piece
filter assembly that you may or may not remove the
elements for thorough cleaning.
4.
Using a garden hose with a spray nozzle, pressure-wash the
filter elements to remove debris.
5.
Wash the inside of the bottom lid.
6.
Replace the filter cartridge into the
Aquashark
.
7.
Install bottom lid and slide latches into lock position.
Filter cleaning solution can be used to remove D.E., excessive
dirt and/or sand.
Remember: The cleaner your filter is, the more efficient your
unit will perform.
CLEANING THE FILTER CARTRIDGE
CAUTION - RISK OF EQUIPMENT DAMAGE
Operating the cleaner with a full filter will result in reduced
performance, limited wall-climbing capability and limited debris
pick-up. Empty and clean the filter, when needed, to maintain
optimal performance. Heavier debris such as sand, pebbles and
rocks may require more frequent cleaning, since they have a
greater effect on the weight and buoyancy of the cleaner.
