- 45 -
Fig. 4
SELF-CLEANING MODE
This mode can help clean the interior of the appliance.
1.
Add water into the water tank. Do not over the Max line.
2.
Plug in the appliance, press the “SELECT” button to choose self-cleaning mode; the “CLEAN” indicator light
will be on.
3.
During self-cleaning mode, pump will draw water into ice making box, then ice making box rotates and pours
the water into water tank. This cycle will repeat for 5 times.
4.
Upon completion, the appliance automatically changes to standby mode.
5.
Empty the water tank. Leave the lid open to allow it to air dry.
Note: A small amount of neutral cleaner can be added into the water. The ratio shall be 1:0.05 (water: neutral
cleaner). When the cleaning is finished, rinse the appliance by repeating once or twice of above steps with clean
water.
CLEANING AND MAINTENANCE
1.
Before cleaning and maintenance, turn off and unplug the appliance and allow it to warm up to room
temperature.
2.
Clean the interior of the appliance with a soft cloth soaked with warm water and vinegar, then rinse with
clean water and then drain all the water. Replace the drain plug well in position.
3.
Wash the ice cube basket and scoop in warm soapy water. Rinse and dry.
4.
Clean the exterior of the appliance with a soft damp cloth.
5.
The self-cleaning should be conducted before you use the appliance for the first time or haven’t used it for
a long time. (See the “SELF-CLEANING MODE” section)
6.
Please empty the water tank and dry it for storage if the appliance is not used for a long time.
Note:
1)
Do not use organic solvent, boiled water, detergent, strong acid and strong alkali etc. for cleaning.
2)
Do not clean the evaporator.
3)
Do not immerise the appliance in water.
TROUBLE SHOOTING
Problem
Possible causes
Solution
“ADD WATER”
indicator lights on
1.Low water level or lack of water
1.Stop making ice, refill water and then press
“ON/OFF” key to restart.
2.The filter at the bottom of water
tank is blocked.
2.Do cleaning
3.Pump malfunction.
3.Send for repair.