09/08
Model 3202/3202G
Page 2 of 4
RECOMMENDED TOOLS:
Hack saw, pipe joint sealant, screwdriver, level, 12" adjustable
wrench, 10" pipe wrench, 5/64“ hex key wrench, 9/16”, 1/2", 7/16” socket wrench or open end
wrench.
LOCATION OF UNIT:
The Model 3202/3202G Drinking Fountain is a wheelchair accessible
drinking water facility. The height dimensions shown, meet current ADA requirements. When
installing this unit, local, state or federal codes should be adhered to. If height other than
shown is required, then dimensions must be adjusted accordingly.
SUPPLY LINE:
The minimum recommended line size is 1/2“IPS with 30-90 psi (2-6 ATM)
pressure. Where sediment or mineral content is a problem, an inlet filter is recommended.
PLUMBING CONNECTIONS:
Inlet is 1/4" IPS male fitting.
MAINTENANCE:
Periodically clean the strainer. Refer to 5874 Valve Manual for more
information.
TROUBLESHOOTING
PROBLEM
REPAIR CHECKLIST
1. Insufficient bubbler flow.
1a. Check that inlet screwdriver stop valve is in
wide-open position.
b. Verify minimum 30 psi flowing supply
pressure.
c. Clean strainer. See 5874 Valve Manual.
d. Adjust valve to increase flow. Use front
adjust screw or see 5874 Valve Manual.
© 2006 Haws
®
Corporation – All Rights Reserved
HAWS
®
and other trademarks used
in these materials are the exclusive property of Haws Corporation.
