09/21
MODEL 1001HO
PAGE 2 OF 5
RECOMMENDED TOOLS
: Hack saw, pipe joint sealant, screwdriver, level, 12" adjustable
wrench,
10" pipe wrench, 3/32” and 5/32 “ hex key wrench, 9/16”, 1/2", 7/16” socket wrench or
open-end wrench.
LOCATION OF UNIT:
The Model 1001HO Drinking Fountain is a wheelchair accessible
drinking facility. The height dimensions shown, meet current ADA requirements. When
installing this unit, local, state or federal codes should be adhered to. If height other than
shown is required, then dimensions must be adjusted accordingly.
SUPPLY LINE
: The minimum reco
mmended line size is 1/2“IPS with 30-90 psi (2-6 ATM)
flowing pressure. Where sediment or mineral content is a problem, an inlet filter is
recommended.
PLUMBING CONNECTIONS:
Inlet is 3/8” O.D. push-in type fitting. Waste outlet is 1-1/4” O.D.
tube.
ELECTRICAL CONNECTIONS
:
Drinking Fountain may be mounted on external wall of
building provided transformer shall be mounted inside the wall and protected from
water per NEC/CEC and local code.
Sensor
:
1001HO with 1RKHO.H
:
100-277VAC x 9VDC, 50-60Hz, 5 Watts.
MAINTENANCE:
Periodically clean out the supply line Y-strainer
INSTALLATION PROCEDURE
GENERAL NOTES:
1. For all plastic push-in type fitting connections, only connect NSF-61 copper or
plastic tubing. Stainless steel or glass tubing is not recommended. The
following assembly instructions must be followed to ensure a watertight
connection:
a. Cut tubing square and clean.
b. Mark from end of tube the length of insertion (See table below).
c. Push tube into the fitting until it bottoms out.
d. To remove, depress collet and pull tubing out.
Tube Sizes
O.D.
Tolerance
Insertion Depth
3/8”
±.00
5”
3/4”
INSTALLATION PROCEDURE…
STEP 1
: Thoroughly flush supply line to remove all foreign matter. Connect
1/2” IPS supply
screwdriver-stop (not supplied). Install supply 3/8
” O.D. tubing (supplied), between
screwdriver-stop and supplied Y-strainer (Cut tubing to proper length and follow
SHOULD YOU EXPERIENCE DIFFICULTY WITH THE INSTALLATION OF THIS
MODEL PLEASE CALL:
TECHNICAL SUPPORT:
1-800-766-5612
FOR CUSTOMER SERVICE:
1-888-640-4297