Hawkeye Mfg AGCO RoGator A Series, Installation Manual

Page: 25 / 54

4
Nozzle Body and Nozzle Control Valve Installation: Nozzle Control Valve 2 (NCV2) Installation 21
NOZZLE BODY AND NOZZLE CONTROL VALVE INSTALLATION
4. If the Wilger-to-Square lug tip adapters are needed to accommodate the tips, install those on the outlets of the
nozzle bodies by rotating them a quarter turn.
FIGURE 6. Wilger Nozzle Body Assembly with Tip Adapter Installed
MILLENNIUM SPRAY BOOMS WILGER NOZZLE BODY INSTALLATION
1. Remove the existing nozzle bodies from the spray boom if necessary.
2. Install the Wilger nozzle bodies with 5-way turrets on the spray boom by aligning the inlet with the hole in the
boom tube at each location.
3. Close the clamp and tighten the screw to secure.
NOZZLE CONTROL VALVE 2 (NCV2) INSTALLATION
1. Locate the Hawkeye® 2 NCVs and the O-rings provided with the kit.
NOTE: Hypro NCV2 and nozzle body will use the purple-colored (size 115) O-rings (P/N 219-2005-115)
Wilger NCV2 and nozzle body will use the black-colored (size 116) O-rings (P/N 219-2005-116)
2. Place the supplied O-ring on the inside of the fly nut flush with the valve body face.
FIGURE 7. Black and Purple O-Rings
3. Align the NCV2 with the port of the nozzle body while being careful not to lose the O-ring.
Tip Adapter
Installed
Black
O-ring
Wilger
Hypro Turret
Purple
O-Ring