Hawk x60, User Manual, Page: 5 / 12

ExIT SLEEP MODE:
Shake the bike to awaken the alarm system and press any button on remote control fob
within 5 seconds, or enter into emergency pin override mode. The system will exit the
sleep mode.
EMERGENCY PIN CODE RESET:
If you cannot disarm the system from the remote transmitter, you will be able to disarm
the system by using the Personal Identification Number (PIN).
The HAWK system leaves the factory with no PIN override in its memory. We feel it is
easier for you, the rider, to enter a number which means something to you and can easily
be remembered. You should never need to use the PIN override, but if you do have to use
it then this system just might make life a bit easier!
TO ENTER THE INITIAL PIN
Step 1
Disarm the system.
Step 2
Turn Ignition ON/OFF 5 times and stopping at ON position at the last time. LED light will
illuminate for 4 seconds.
Step 3
When LED Light is illuminated press the button once to enter pin code mode.
You can now enter the pin of your choice; ie say 4 digits - 1234
Ignition on, count LED 1 flash ignition off 1
Ignition on, count LED 2 flash ignition off 2
Ignition on, count LED 3 flash ignition off 3
Ignition on, count LED 4 flash ignition off 4
You will get one chirp, and you will need to confirm the PIN
Ignition on, count LED 1 flash ignition off 1
Ignition on, count LED 2 flash ignition off 2
Ignition on, count LED 3 flash ignition off 3
Ignition on, count LED 4 flash ignition off 4
You will get 2 chirps to confirm the PIN has been entered successfully.
(3 chirps means that first and second entry of the PIN did not match- try again!
Go to Step 1)
IF YOU GET IT WRONG
Should you get it wrong or distracted at any point in this process, and you want to start the
process again, simply disarm the alarm with the transmitter.
3