9
Remove dust cover from side of alarm main control box. Adjust shock sensor
sensitivity with screw driver according to user need.
In arm mode LED will flash twice within interval of 2 seconds. This will
indicate alarm is on arm mode.
If system triggered by shock sensor LED will flash continuously for 30
seconds then the LED will flash 4 times within interval of 4 seconds until the
system is disarmed.
If the system is triggered by ignition on (anti-hotwire), the LED will flash
continuously until system is disarmed and Ignition turned on.
During the alert state, if the alarm is detached from the cable harness, when
restored it will “remember” the state in which was, preventing in this way
every attempt of tampering.
The included transmitters are pre programmed into the systems memory at
the factory. Follow the below steps to add or delete a new transmitter.
1.
In disarming mode, Ignition OFF position. Open the main control box.
Press and hold the Micro switch. Press any button of 1
st
LCD remote fob.
LED will flash twice and siren will bleep twice. The first remote fob will
respond with Musical note indicating code learned successfully.
2.
Within 8 seconds press any button of 2
nd
LCD remote fob, LED will flash
four times and siren will bleep four times. The second remote fob will
respond with Musical note indicating code learned successfully.
3.
To exit code learning mode, release Micro switch and close the control
box.
ADJUSTING SHOCK SENSOR
LED FUNCTION / ALARM MEMORY:
MEMORY FUNCTION
LEARNING TRANSMITTER CODES: (We have already done this for you!!!)
