BRUSH AND PAD DRIVER
INSTALLATION
NOTE: Disconnect the power cord from the
electrical outlet before installing a brush or pad
driver.
To install a brush or pad driver, leave the handle in
the upright position and tip the machine backwards
so it rests on its wheels and upper handle section
(Figure 4). The brush and pad driver both attach in
the same manner; align the cut-outs on the inner
ring of the brush or pad driver with the tables on the
inside of the ring of the drive hub (Figure 5). Push
the brush or pad driver firmly in position, then turn
it counter-clockwise until it locks into place. To
remove, turn the brush or pad driver clockwise until
it stops, and then lift it off.
NOTE:
Always remove
the brush or pad driver when the machine is not in
use.
NOTE: Disconnect power cord from the
electrical outlet before installing or removing
brush, pad, or pad driver.
ADJUSTMENTS
HANDLE ADJUSTMENT
The handle can be adjusted to any desired work
position by simply pushing up on the handle lock
(Figure 5). Move the handle to the desired position,
then firmly push down on the handle lock which
will lock the handle in position.
HANDLE CAM LOCK ADJUSTMENT
With the handle cam lock in the “up” position
(unlocked), tighten the adjusting nuts until there is
a slight drag when the handle is raised or lowered.
The tube should be locked securely when the
handle lock is pressed downward (Figure 6).
ON
OFF
UNLOCK
LOCK
UNLOCK
LOCK
ADJUSTING NUT
CONTROLS
ON/OFF POWER SWITCH TRIGGERS
The ON/OFF switch is conveniently located in the form
of dual triggers underneath the handle grips.
TO TURN THE MACHINE ON
The operating handle must be lowered to the operat-
ing position before switching the machine ON. Place
both hands firmly on the handle grips with your fingers
around the power triggers. Do NOT apply pressure on
the triggers before the safety switch lock is disengaged.
Disengage the safety switch lock by pushing it forward
with one thumb. Then, while holding the safety switch
lock in the disengaged position, squeeze the power trig-
gers toward the handle grips and return your thumb to
the handle grip. (See figure 7 )
To stop the machine, simply release the triggers. The
safety switch lock will automatically return to the
engaged position. (See figure 7 )
Figure 4
Figure 5
Figure 6
4
