SC1502 AUDIO SYSTEM
INSTALLATION GUIDE
HAWG WIRED, INC.
PAGE 4
FREMONT, CA
I
I
N
N
S
S
T
T
A
A
L
L
L
L
A
A
T
T
I
I
O
O
N
N
I
I
N
N
S
S
T
T
R
R
U
U
C
C
T
T
I
I
O
O
N
N
S
S
1. TURN OFF THE IGNITION AND REMOVE THE SEAT.
TIP: REFER TO MANUFACTURER INSTRUCTIONS IF NECESSARY.
2. DISCONNECT THE BATTERY.
TIP: ALWAYS DISCONNECT THE NEGATIVE SIDE FIRST, POSITIVE SECOND.
3. REMOVE THE FRONT FAIRING COVER.
TIP: REFER TO MANUFACTURER INSTRUCTIONS IF NECESSARY.
4. PLACE A SMALL AMOUNT OF DIELECTRIC GREASE ON EACH CONTROL CABLE CONNECTOR, THE
CONTROLLER MODULE, AND ON EACH AMPLIFIER MODULE, FOCUSING ON THE ELECTRICAL
CONTACTS.
5. WITH BOTH AMPLIFIER CONTROL CABLES ATTACHED, MOUNT
1
THE CONTROLLER MODULE; TYPICAL
BATWING MOUNTING GOES ON TOP OF THE RADIO, WHILE THE SHARK-NOSE FAIRING REQUIRES
SIDE MOUNTING ON THE FLAT AREA UNDERNEATH THE GLOVE BOX.
TIP: ON 2006 BATWING MODELS: IF ONE OF THE TWO MODULES (XM SATELLITE RADIO OR CB COMMUNICATIONS) IS
INSTALLED ON TOP OF YOUR RADIO, YOU WILL NEED TO INSTALL OUR HKA150 ADAPTER BRACKET IN THE BLANK
MODULE SLOT. IF BOTH MODULES ARE INSTALLED, MOUNT THE CONTROLLER ON TOP OF THE MODULES. IF
NEITHER MODULE IS INSTALLED, CUT THE LARGE VELCRO® PIECE IN HALF IN ORDER TO PLACE ONE PIECE ON
EACH SIDE OF THE RIB DOWN THE CENTER OF THE RADIO, THEN MOUNT THE CONTROLLER ON TOP OF THE RADIO.
IN ALL INSTALLATION SITUATIONS, ENSURE THAT THE CONTROLLER IS POSITIONED AS FAR BACK AS POSSIBLE.
6. ON BATWING MODELS, REMOVE BOTH SPEAKER BRACKETS AND INSTALL THE AMPLIFIER MOUNTING
BRACKETS USING THE FACTORY HARDWARE. NOW MOUNT
1
YOUR AMPLIFIERS TO THE BRACKETS
USING THE VELCRO
®
PATCHES PROVIDED.
