RC104 RC-LINK AMPLIFIER REMOTE CONTROL MODULE
INSTALLATION GUIDE
HAWG WIRED
PAGE 5
FREMONT, CA
U
U
S
S
E
E
R
R
G
G
U
U
I
I
D
D
E
E
REMOTE CONTROL OVERVIEW
AMPLIFIER STATUS OVERVIEW
THE RC-LINK REMOTE CONTROL HAS TWO BASIC MODES OF OPERATION WHEN
CONNECTED TO THE RC-LINK PORT(S) OF YOUR AMPLIFIER(S); MONITOR AND
PROGRAM. PRESSING THE AMPLIFIER SELECT BUTTON CYCLES BETWEEN THESE
TWO MODES.
MONITOR MODE (DEFAULT POWER-UP MODE):
THE APPLICABLE AMPLIFIER LEDS WILL LIGHT UP FOR EACH AMPLIFIER
DETECTED. THE LED CORROSPONDING TO EACH AMPLIFIER DETECTED WILL
FLASH IF AN OVER-CURRENT, OVER-DRIVE (CLIPPING), OR OVER-TEMPURATURE
CONDITION OCCURS. ALL DETECTED AMPLIFIERS WILL FUNCTION NORMALLY IN
MONITOR MODE. GAIN AND FREQ LEDS WILL BE OFF.
PROGRAM MODE:
ONLY THE LED CORROSPONDING TO THE AMPLIFIER BEING PROGRAMMED WILL
LIGHT UP, LEAVING ALL OTHER AMPLIFIER STATUS LEDS OFF. EACH AMPLIFIER
NOT BEING PROGRAMMED IS ALSO ATTENUATED (MUTED), LEAVING ONLY THE
CURRENTLY SELECTED AMPLIFIER FUNCTIONING NORMALLY FOR
PROGRAMMING. THE LED CORROSPONDING TO THE AMPLIFIER BEING
PROGRAMMED WILL STILL FLASH IF AN OVER-CURRENT, OVER-DRIVE (CLIPPING)
OR OVER-TEMPURATURE CONDITION OCCURS DURING PROGRAMMING.
NOTE: ONCE THE REMOTE HAS ENTERED INTO PROGRAMMING MODE, THE ADJUSTMENT
KNOBS ON EACH AMPLIFIER DETECTED WILL BE DISABLED, REGARDLESS OF WHETHER
OR NOT ANY SETTINGS ARE CHANGED, AND WILL REMAIN DISABLED UNTIL EACH
AMPLIFIER IS RESET MANUALLY (SEE RESETTING THE AMPLIFIER(S) IN THE TEST AND
TUNE SECTION OF THIS MANUAL).
WARNING: USE ONLY HAWG WIRED PROVIDED RC-LINK CABLES AND COUPLERS. WHILE THEY RESEMBLE TYPICAL
HOUSHOLD PHONE WIRES, THEY ARE NOT. NO OTHER DEVICE OR CABLE SHOULD EVER BE CONNECTED TO THIS JACK,
AND DOING SO COULD DAMAGE YOUR DEVICE AND VOID YOUR WARANTY.
BATTERY STATUS OVERVIEW
THE RC-LINK REMOTE CONTROL HAS A BUILT-IN BATTERY MONITOR THAT
REPORTS THE STATUS OF YOUR CHARGING SYSTEM.
BATTERY MONITOR (OPTIONAL):
WITH THE CIGARETTE LIGHTER ADAPTER CABLE CONNECTED TO THE REMOTE
CONTROL MODULE, THE BATTERY STATUS LEDS INDICATE THE CURRENT STATE OF
THE CHARGING SYSTEM. THE BATTERY STATUS MONITOR FUNCTIONS
INDEPENDENT OF THE AMPLIFIER MODES, AND IS NOT REQUIRED FOR AMPLIFIER
STATUS OR PROGRAMMING.
WARNING: USE ONLY HAWG WIRED PROVIDED CIGARETTE ADAPTER CABLES WITH THIS DEVICE. NO OTHER DEVICE OR
CABLE SHOULD EVER BE CONNECTED TO THIS JACK AS POLARITY (+/-) AND POWER JACK SIZES MAY VARY. DOING SO
COULD DAMAGE YOUR DEVICE AND VOID YOUR WARANTY.
