C-VS-1900-INUT-PM _INST_7-17
Attach side trim panel to console housing with two (2)
8 x 3/8” Torx screws and one (1) #10 x 3/4´sheet metal
screw to lower dash.
Remove side trim panel and place supplied speed
nut onto drilled location. This provides a sturdy
mount for trim panel screw.
(follow same procedure on both sides)
Attach rear bracket to existing OEM mounting
flanges with 6mm x 20mm hex bolts.
Temporarily attach side trim to console with
8 x 3/8” Torx screws and drill 1/8” hole into plastic
dash panel located behind forward hole.
Place console housing between seats and attach
sides to floor brackets with 1/4” x 3/4" Hex bolts
and flat washers.
Sensor can be mounted on the underside of the rear
mount bracket for the Interior upgrade 65U.
Harness may not be long enough for standard Utility.
Front of
vehicle
