C-TMW-EC-01_INST-1-19
2
Remove the Front and Rear inboard seat bolts.
(Bolts closest to center of vehicle)
T-55 Torx bit needed.
Place passenger side forward leg in position
between the floor and seat base.
Re-attach seat bolt. Do not tighten bolt yet.
Repeat on driver side forward leg.
Place passenger side rear leg in position
between the floor and seat base.
Re-attach seat bolt. Do not tighten bolt yet.
Repeat on driver side rear leg.
Loosely attach center plates to legs with ¼” x ¾”
hex head bolts and flat washers.
Note: You may want to remove these plates to
attach the extrusion hardware in the next step.
Attach Tunnel Extrusion to center plates with
¼” x ¾” hex head bolts and serrated nuts.
Note: The head of the bolt slides into the
bottom of extrusion.
Position extrusion as desired and tighten all hardware.
The C-TMW-ECO-01 is now ready to mount a console
or other accessories.
The self adhesive plastic end caps go on after the top
mounted hardware is inserted into extrusion slots.