Havis C-DMM-3016 Installation Instructions Manual Download Page 6

Page: 6 / 6

C-DMM-3016_INST_4-20

Place frame over radio, HVAC controller, and

outer mounting brackets.

Route wiring as needed along the side of the DMM frame

using wire tie holes.

Test up / down and side to side motion

to confirm wires have adequate slack and strain relief.

Installation is now complete

Determine desired position for your specific computer and

attach to DMM swivel plate using 1/4"x 3/4” carriage bolts,

PVC spacer, nylon washers, steel washers, and nylock nuts.

Tighten so that the dock rotates smoothly.

Tighten using 1/4" x 3/4" Phillips head bolts and

#10 star washers.

Position VESA plate on back of Device as desired.
Attach VESA plate with carriage bolts to the back

of the dock. The gray PVC washer will go between

this bracket and the DMM swivel plate.

Tighten radio and HVAC controller through access

holes in front of frame. Cover holes with 3/8” dome

plugs supplied with kit.

Summary of Contents for C-DMM-3016

Page 2: ...C DMM 3016_INST_4 20 C DMM 3016 CM010204 DS CM010204 PS CM010205 PS CM010205 DS GSM33001 GSM31035 GSM33124 GSM33124 GSM20013 CM010471 CM010648 GSM30016 1 GSM31005 CM86600 GSM32000 ...

Page 3: ...e reused 7mm head screw Carefully remove driver side lower dash panel It may not be necessary to be completely removed Detach center dash panel and pull out passenger side only as far as needed to remove the AM FM radio Carefully remove passenger side lower dash panel It may not be necessary to be completely removed 10 mm socket ...

Page 4: ...usly removed dash Attach inner passenger side mounting bracket to dash using previously removed OEM hardware Unplug all connectors from rear of OEM HAVC controller Attach inner driver side mounting bracket to dash using previously removed OEM hardware Remove plastic radio mounting ring This will not be reused ...