C-DMM-3004_INST_4-20
Attach the DMM frame to the brackets using 10-32
x 1/2" screws and washers at the top and 10-32 x
1/2" screws, washers, and keps nuts on the side.
Installation is now complete.
Double check all hardware, latching and wire
harness clearance.
Position VESA plate on back of Device as desired.
Attach VESA plate with carriage bolts to the back
of the dock. The gray PVC washer will go between
this bracket and the DMM swivel plate.
Attach the dock to the mounting bracket (with hardware
supplied with dock) and run wires as desired.
Determine desired position for your specific computer
and attach to DMM swivel plate using 1/4"x 3/4” carriage
bolts, PVC spacer, nylon washers, steel washers, and
nylock nuts. Tighten so that the dock rotates smoothly.