KK-C-ST-SS-INST-9-06
SUBASSEMBLY:
1.
Bolt floor mounted side brackets to the side bracket supports using the views on the following
page that is vehicle specific. Loosely attach using ¼” x ¾” carriage bolts, flat washers, lock
washers, and hex nuts.
2.
Determine height of adjustable frame rail support.
•
Hold floor mounted side bracket to the underside of the van floor between the frame and
the fender to determine the height.
•
With the specific height determined loosely attach using ¼-20 x 1” hex head bolts
,
flat
washers, lock washers and hex nuts.
•
This will square the backside of the step.
INSTALLATION:
1. PREP THE VAN:
•
Pull up carpet along the side door of the van. To do this you must remove the plastic step
well trim piece.
•
Locate the center of the side doors and make a visible mark in order to center the side
step.
2. BOLT STEP ASSEMBLY TO VAN:
Note: The frame rail support will not sit flush to frame rail on van.
•
Position assembly tight to floor of van with frame rail support tight to frame of van.
Mark and drill (4) ¼” holes through floor of van using holes in floor mounted side
brackets as a template.
Note: side bracket supports may have to be temporarily removed in order to properly position step
between fender and frame rail.
•
Position step assembly then loosely reattach side bracket supports.
•
Bolt step to floor using ¼-20 x 1” hex head bolts
,
flat washers, lock washers and hex
nuts.
3. FINAL INSTRUCTIONS:
•
Loosen side bracket supports and position tight to fender lip.
•
Mark and drill (4) ¼” holes into fender lip using side bracket supports as a template.
•
Attach side bracket supports to fender lip using ¼-20 x 1” hex head bolts, flat washers,
lock washers and hex nuts. .
•
Check that step slides smoothly and goes to the closed position. Replace carpet and step
sill trim.
