Havis-Shields Kwik-Kit KK-100-05, Install Instructions Manual

Page: 2 / 22

KK-XXX-05_INST_8-07
2
40” COMPARTMENT (cont):
QTY DESCRIPTION PART
# USED FOR:
40 #10 x 1” Phillips pan head sheet metal screw GSM33196 Floor, wall to ceiling
25 #8 x 3/8” Phillips flat head screw GSM33179 Vent plates/dome lights
5 ½” Flat washer GSM31009 Grab straps/seat belts
5 ½” Lock washer GSM31030 Grab straps/seat belts
5 ½” x 1 ¼” Socket button head bolt GSM33310 Grab straps/seat belts
5 3/8” x 2” Hex head bolt GSM33032-1 Bulkheads
5 3/8” Hex nut GSM30008 Bulkheads
5 3/8” Lock washer GSM31028 Bulkheads
5 3/8” x 2” Fender washer GSM31022 Bulkheads
2 A/C Vent plate KKM0403-001 Ceiling (vent adapter kit)
1 Dome light KK-DOME-2 Ceiling
HARDWARE – DIVIDER:
QTY DESCRIPTION PART
# USED FOR:
28 ¼” x 1 ½” Hex head lag bolt GSM33062 Divider to floor
14 ¼” x 5/8” Stainless socket button head bolt GSM33308 Divider
7 ¼” x ¾” Stainless socket button head bolt GSM33309 Divider
14 ¼” Stainless flat washer GSM31048 Divider
10 #10 x ½” Phillips flat head machine screw GSM33072 Door frame to divider
10 #10 Thin nylock nut GSM330015-1 Door frame to divider
Always
!
¾
Read all instructions before installing any Havis-Shields Equipment Corp products.
¾
Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
¾
Use hardware provided with install kit
¾
For product support, visit the Install Instructions Section of our website at
http://havis.com/Installation/Installation.html , email technicalsupport@havis.com or call
1-800-524-9900.
¾
If this is your first time installing a Havis Shields Equipment Corp Prisoner Transport,
please contact the factory for tips and suggestions that will ease the installation.
VEHICLE PREPERATION:
1. STEPS, HVAC, VAK, OPTIONS, ETC:
•
Refer to the specific install instructions. Installing the steps prior to installing the
kwik kit will ease installation and must be done on Chevy side step.
•
Installing options may be necessary prior to installing the kit.
2. SOUND DEADENING & FLOORING:
•
OPTION #1: KK-RFM A self-adhesive rubber sound deadening floor mat is sold
separately and will help deaden road noise.
•
Install optional rubber flooring onto van floor. Rubber floor mat should go under
OEM floor mat in drivers compartment to cover sheet metal floor.
•
Excess material can be placed onto walls of the van, around the wheel wells, inside
door panels, etc. This will also help deaden the echo in the vehicle.
•
OPTION #2: 3/8” to ½” plywood can also be used as an alternative solution. Cover
the entire cargo floor of the van. (1 ½) – 48” x 96” sheets of plywood are needed.
Havis Shields Equipment Corp does not supply plywood floor kit.
Draw a line on the
rubber/wood floor from rear doorframe as shown on the following page. This will be
the starting point of the kit.