Haussmann 59595029, Operator'S Manual

Page: 20 / 25

20
ENGLISH
SAFETY INSTRUCTIONS
SPECIFIC SAFETY RULES
5. Service
a) Have your power tool serviced by a qualified repair person using
only identical replacement parts. This will ensure that the safety of the
power tool is maintained.
b) When servicing a tool, use only identical replacement parts. Follow
instructions in the maintenance section of this manual. Use of
unauthorized parts or failure to follow maintenance instructions may
create a risk of electric shock or injury.
Secure the material being planed. Never hold it in your hand or across
legs. Small work pieces must be adequately secured so that the rotating planer
blades will not pick it up during forward motion of the planer. Unstable support
can cause the blades to bind causing loss of control and injury.
Always start the planer before blade is in contact with the work piece and
allow the blade to come to full speed. Tool can vibrate or chatter if blade
speed is too slow at beginning of cut, which may cause kickback.
Check the work piece for nails, if there are nails, either remove or set them
well below intended finished surface. If the planer blades strike objects like
nails it may cause the tool to kickback and serious personal injury may result.
Unplug the planer before changing accessories. Before plugging the tool
in, check that the trigger lock is "OFF". Accidental start-ups may occur if
planer is plugged in while changing an accessory.
After changing blades, rotate the blade cylinder (cutter drum) to make sure
blades are not hitting any part of the blade head housing and the blade
locking screws are tight. Spinning blades could strike tool housing and
damage tool as well as possible injury.
Always hold the tool firmly with both hands for maximum control.
Never pull the planer backward over the work piece. Loss of control may
occur.
Do not put fingers or any objects into the chip ejector or clean out chips
while tool is running. Contact with blade drum will cause injury.
Remove plug from power source if it becomes necessary to remove chips.
The blades are hidden from view and you may be cut if blade is contacted.
Never place the planer down until the blade is completely at rest. Surface
contact with coasting blade drum may cause the planer to walk out of control.
Some examples of these chemicals are:
• Lead from lead-based paints,
• Crystalline silica from bricks and cement and other masonry products, and
• Arsenic and chromium from chemicallytreated lumber. Your risk from these
exposures varies, depending on how often you do this type of work. To reduce your
exposure to these chemicals: work in a well ventilated area, and work with approved
safety equipment, such as those dust masks that are specially designed to filter out
microscopic particles.
WARNING! Some dust created by power sanding, sawing, grinding, drilling, and other
construction activities contains chemicals known to cause cancer, birth defects or other
reproductive harm.