HAUSSLER HM 70, Operating Instructions Manual

Page: 47 / 60


Then switch on the sifting device.

Press the “Mill ON/OFF” switch
E
.
i
Wait for the machine to reach full speed.The controller prevents metering from
being activated so that the millstones are not blocked by grain when the motor
starts up.

Turn the adjusting wheel
6
slowly towards “Fine”until the millstones just about
make contact.
i
You will hear an audible grinding noise when the stones come into contact.
 Turn the fixing bolts
H
to secure the adjusting wheel
6
.

Turn the “Dosage u/min” switch
C
to the center position.

Press the “Dosage u/min” switch
C
.
i
Adjust the dosage controller (“Dosage u/min”
E
) to vary the throughput rate.

Set the adjusting wheel
6
to the required milling fineness while the grain is being
fed into the mill.

Turn the fixing bolts
H
to secure the adjusting wheel
6
.
i
Switching off the equipment

Press the “System ON/OFF” switch
G
.
Switching off the equipment

Press the “System ON/OFF” switch
G
.
i
The equipment switches itself off automaticallyin the following predefined order:
metering device (duration approx. 18 seconds), mill (duration approx. 18 seconds),
sifting device (duration approx. 2 min). Do not intervene in the process. This order
of events results ensures that there is no grain left in the milling chamber after the
millstones have come to a standstill. Any leftover grain would cause a blockage of
the millstones on starting up.

After milling, turn the adjusting wheel
6
to set the mill to “Coarse”.
47
Sifting