Maintenance and repairs
Page 14
7
Maintenance and repairs
_____________________________________________________________________________________
WARNING!
High voltage!
Danger of fatal accidents!
Do not open unit!
_____________________________________________________________________________________
This unit does not include any parts which can be maintained or repaired by
the operator. HAUG only is authorized to repair or calibrate the unit.
Should the unit prove defective or if a defect is suspected, switch off unit
immediately and secure against subsequent reuse.
7.1
Replacing fuse
1.
Switch off unit.
2.
Determine and remove the cause for the blown fuse.
3.
Detach the fuse holder using a screwdriver and lift out.
4.
Replace fuse and reattach fuse holder.
Use the following fuses only:
Unit type
Fuse
EN SL (MT) 100 / 115 V
T 500 mA L 250; 5x20 mm
EN SL (MT) 230 V
T 250 mA L 250; 5x20 mm
The unit type and the rated voltage are indicated on the nameplate.
Only use fuses of the type indicated.
7.2
Accessories
Article
Order
number
One Point Ionizer
03.8510.200
Punkt – Elektrode XP
03.8513.200
Punkt – Elektrode XP (Set)
23.8513.100
U – Elektrode
05.8091.100
U – Elektrode (Set)
23.8091.100
Summary of Contents for EN SL MT Series
Page 1: ...Power Pack EN SL Version MT Static Line Operating instructions...
Page 2: ......
Page 4: ...This page has been left intentionally blank...
Page 19: ......
