4
ASSEMBLY INSTRUCTIONS
1. Attach one LEG PANEL #4 to one RIGHT LEG #2 and one LEFT LEG #3 as shown below with
2. Thread one LEG LEVELER #13 to each LEG.
3. Attach assembled LEGS to TABLE BODY #1 with BOLT #6 and FLAT WASHER #7.
Note: The
table is assembled upside down.
4. Carefully turn table over. Attach one GOAL #5 to each end of the table with 5/8" SCREW #15.
Attach Electronic Scorer #14 with 5/8” SCREW #15 and insert leads A & B from Sensor Wires #16.
Insert the lead “ A ”
into the “ A ” receptacle.
Insert the lead “ B ”
into the “ B ” receptacle.
1/2" SCREW #8. Repeat assembly with remaining LEG PANEL and LEGS.
Note: Leg panel graphic
will face out and curved end down when table is upright.
#16
TIP: It may be easier to
attach legs to table body
in Step 3 if you leave #8
screws a little loose until
legs are attached and
