OPERATION
Form No. HBGm-1111
9
General
Use the following procedure to turn on and operate a Heated
Black Glass Shelf.
Read all safety messages in the IMPORTANT SAFETy
INFORMATION section before operating this equipment.
Do not turn on unit until it has been cleaned thoroughly.
Ceramic glass surface must be clear of debris to prevent
burn-on.
Use only wipes, pads, and cleaners designed specifically
for cleaning ceramic glass surfaces. Using other wipes,
pads, or cleaners may damage ceramic glass surface.
Do not slide pans across glass surface, use rough-
bottomed pans, or drop anything on glass surface.
Scratching or breakage may occur. Damage to glass
surface or breakage of glass caused by misuse is not
covered under warranty.
1. Using an appropriate cleaning wipe or a damp cloth, clean
the glass surface of the unit. Consistent daily cleaning will
keep cleanup easy as well as protect and preserve the
glass surface of the unit.
2. Plug unit into a properly grounded electrical receptacle of
the correct voltage, size, and plug configuration. See the
SPECIFICaTIONS section for details.
NOTICE
WARNING
Power ON/OFF
(I/O) Switch
Temperature Control
Figure 9. Standard Control Panel
3. move the power ON/OFF (I/O) switch to the ON (I) position.
BURN HAzARD: Some exterior surfaces on the unit will get
hot. Use caution when touching these areas.
4. Turn the temperature control to the desired temperature
setting.
NOTE: Turning the temperature control clockwise will increase
the temperature setting. Turning the temperature control
counterclockwise will decrease the temperature setting.
5. allow the unit 30 minutes to reach operating temperature.
NOTE: Refer to the
OPTIONS aND aCCESSORIES
section for
installation and operation information for HBGB units
equipped with the flush mount control box.
CAUTION
Summary of Contents for HBG-2418
Page 15: ...15 Form No HBGm 1111 NOTES...
