Hatco 07.04.668.00, Installation And Operating Manual

Page: 7 / 16

Form No. TPTDm-1113
7
OPERATION
General
The Pop-Up Toaster is designed for ease of operation. Perform
the following procedure to operate the toaster.
Read all safety messages in the IMPORTANT SAFETy
INFORMATION section before operating this equipment.
1. Plug the unit into a properly grounded electrical receptacle
of the correct voltage, size, and plug configuration. See the
SPECIFICaTIONS section for details.
2. Set the COLOR CONTROL knob(s) to the desired toast
darkness setting. The “1” setting on the COLOR CONTROL
knobs represents the lightest toast setting and the “7”
setting represents the darkest.
3. For TPT-208D and TPT-240D toasters, make sure the
TOaST/BaGEL button(s) is in the correct position. Push the
TOaST/BaGEL button(s) to change its setting, if necessary.
• When the TOaST/BaGEL button(s) is in the TOaST
position (depressed), both heating elements in each
toasting slot will energize to toast both sides of the
product.
• When the TOaST/BaGEL
button(s) is in the BaGEL
position (released), only
the inner heating elements
in each pair of toasting
slots will energize to toast
the inner side of the
product.
4. Place bread product in
toasting slot(s). If toasting only
one side of the product, make
sure to place the toasting side
toward the center of each pair
of toasting slots.
WARNING
5. Push down on the operating lever(s) to lower product into
the toaster.
• as soon as the operating lever is pushed down, the
heating elements inside the toaster energize and begin
heating.
BURN HAzARD: Some exterior surfaces on unit will get hot.
Use caution when touching these areas.
• When the toasting cycle is complete, the heating
elements shut off and the operating lever(s) rises
automatically.
NOTE: The operating lever(s) can be lifted manually during
toasting for product removal. This will end the toasting
cycle.
ELECTRIC SHOCK HAzARD:
• Unplug power cord and allow unit to cool before
performing maintenance, cleaning, or attempting to clear
a jam.
• NEvER insert a knife, fork, or similar object into toasting
chamber.
6. Remove and empty the crumb trays periodically in between
toasting cycles.
Always operate toaster with crumb trays installed.
Toasting of coated or buttered products such as garlic bread,
cheese sandwiches, and sweet rolls is NOT recommended.
Residue will reduce toaster performance and could ignite
inside toaster. Using toaster with food products listed above
will void unit warranty.
WARNING
CAUTION
CAUTION
COLOR CONTROL
Knob
COLOR CONTROL
Knob
TOAST/BAGEL Button TOAST/BAGEL Button
TPT-208D and TPT-240D Control Panel