8.
Maintenance
Keep clean will prolong service life treadmill, therefore clean the running belt and running deck regularly is encouraged, soft
cloth with soapy water could be adopt to clean the belt but do not pour water to flushing or the motor and other electronics
parts properly be damaged.
8.1.
Lubrication of Running Belt and Running Deck
Lubricant for running deck and running belt is necessary, but it does not means the more the better, suggestion as
follow:
Working Time Per Week
Lubrication Time Cycle
No more than 3 hours
half year
3~6 hours
Three months
More than 6 hours
One month
8.2.
Judge Friction of Running Belt and Running Deck
Forget to clean or lubricants reduce probably increase the friction of the running belts and the running deck, even
to damage the motor and control panels. High friction usually reflect as below
1)
Belt is hard to move when power off.
2)
Belt stop moving at once press the EMERGENCY STOP BUTTON when user running on belt.
3)
Motor, control panel been damaged, the circuit breakers is broken.
8.3.
Running Belt Deviation Adjustment
The running belts position has been tested and adjusted before shipping, whereas it will be found lean after running
sometimes, probably due to
1)
Horizontal body is not stable; please adjust the bolt under treadmill.
2)
The user likes to run at one side but not at the middle of belt;
3)
Uneven force;
Artificial causes could be fixed easily by no-load running in a few minutes, but user should take hex screw to screw
the bolt
.
Problems
Left Regulator
Right Regulator
Deviation to left
rotate clockwise
rotate counterclockwise
Deviation to Right
rotate counterclockwise
rotate clockwise
Running belt with a deviation does not belong to the warranty scope,
generally maintenance by the user. Deviation will seriously damage
the running belt, must check in time, immediately correct.
8.4.
Running Belt Tension Adjustment
1)
Tighten: screw the
in a clockwise direction 180degree by
180degree with Hexagonal screwdriver.
2)
Loosen: screw the
in a counterclockwise direction
180degree by 180degree with Hexagonal screwdriver.
As right images shows
8.5.
Motor Belts Adjustment
The position of motor belts has been tested and adjusted before
shipping, whereas it is will be found loosen after working certain
hours, open the motor cover
then screw the bolt according 180
by 180 degree upon the particular circumstances.
7
