OBJECT
Pet and pass the pup! If you’re holding him when he pees, you’re out!
Be the only player not to get peed on by the pup to win!
THE FIRST TIME YOU PLAY
Attach the tail to the back of the pup.
Insert batteries as shown on far right.
GET READY!
1.
Open the rubber dog tag on the pup’s body and
completely fill the body with clean tap water.
Then push the dog tag firmly back into place.
2.
Press down firmly on the pup’s tail and release.
3.
Press the pup’s tongue once. (If water does not
spray out of the tiny hole on the front of his
body, repeat Steps 2 and 3 until it does.)
4.
Once water has sprayed out, press down firmly
on the pup’s tail once more and release to start
the game!
AGES
4
+
2+
PLAYERS
E3043
© 2017 Hasbro, Pawtucket, RI 02861-1059 USA.
All Rights Reserved. TM & ® denote U.S. Trademarks.
Consumer contact:
USA and Canada: Hasbro Games, Consumer Affairs Dept.,
P.O. Box 200, Pawtucket, RI 02861-1059 USA. TEL. 800-255-5516.
Australia consumer service: [email protected]
New Zealand consumer service: [email protected]
CONTENTS: Peeing Pup game unit • plastic tail
LET’S PLAY!
All players stand in a circle! The last person who petted a dog goes first!
The game begins when the first player starts petting the pup. Play
continues to the left.
ON YOUR TURN:
1.
Hold the pup in one hand so he’s facing you, then use
your other hand to pet the entire brown patch of
hair on his head from front to back as shown.
2.
Keep petting the pup until he barks three times.
That’s your signal to pass him to the next player!
(He might make other sounds, such as a hiccup
or a whimper, but those don’t count. Keep petting
until you hear “Ruff! Ruff! Ruff!”)
3.
If the pup
does not pee
while you’re holding
him, you’re safe, and it’s the next player’s turn.
If he
does pee,
you’re out, and you must reset
the pup so the remaining players can continue.
To
reset the pup
, press down firmly on his tail
and release.
WIN!
Continue to take turns petting and passing the pup until only one person
is left. The only player not to get peed on by the pup wins!
DONE PLAYING?
1. Open the dog tag on the pup’s body and pour out all the water.
2. To ensure that no water remains inside the pup, press down firmly
on his tail and release, then press his tongue once. (Repeat this entire
step, in the order described, until water stops spraying out of the tiny
hole on the front of the pup’s body.)
3. Let the pup dry thoroughly before replacing the dog tag.
NOTE:
The game shuts down after one minute of
inactivity. To turn off the game manually, press down
firmly on the pup’s tail and hold for two seconds.
Watch out!
If you accidentally press the
pup’s tongue and water sprays, you’re out!
WARNING:
CHOKING HAZARD–Small parts.
Not for children under 3 years.
CAUTION:
TO AVOID INJURY: Use only clean tap water. Dry thoroughly
after use. Read instructions for use and care.
ADULT ASSEMBLY REQUIRED.
IMPORTANT:
BATTERY INFORMATION
CAUTION:
1. As with all small batteries, the batteries used
with this product should be kept away from
small children who still put things in their
mouths. If they are swallowed, promptly see a doctor and have the doctor
phone (202) 625-3333 collect. If you reside outside the United States, have
the doctor call your local poison control center.
2. TO AVOID BATTERY LEAKAGE
a. Always follow the instructions carefully. Use only batteries specified
and be sure to insert them correctly by matching the + and – polarity
markings.
b. Do not mix old batteries and new batteries or standard (carbon-zinc)
with alkaline batteries.
c. Remove exhausted or dead batteries from the product.
d. Remove batteries if product is not to be played with for a long time.
e. Do not short-circuit the supply terminals.
f. RECHARGEABLE BATTERIES: Do not mix these with any other types of
batteries. Always remove from the product before recharging. Recharge
batteries under adult supervision. DO NOT RECHARGE OTHER TYPES OF
BATTERIES.
3. Should this product cause, or be affected by, local electrical interference,
move it away from other electrical equipment. Reset (switching off and
back on again or removing and re-inserting batteries) if necessary.
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy, and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
Caution:
Changes or modifications to this unit not expressly approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
CAN ICES-3 (B) / NMB-3 (B)
TO INSERT BATTERIES
Use a Phillips/cross head
screwdriver (not included).
ALKALINE BATTERIES REQUIRED
NOT INCLUDED
x3
1.5V
AAA
+ -
- +
+ -
+ -
- +
+ -
+ -
- +
+ -
+ -
- +
+ -
+ -
- +
+ -
+ -
- +
+ -
+ -
- +
+ -
+ -
- +
+ -
®
ing
P
ee
ing
P
ee
ing
P
ee
P
U
P
P
U
P
P
U
P
P
U
P
P
U
P
P
U
P
ing
P
ee
ing
P
ee
ing
P
ee
E3043CU00 I PeeingPup.indd 1
3/2/18 5:18 PM
