5008/ id_94819_MLP_Plane/2009-11-043/A/FW13/
200
214
5008/ id_94819_MLP_Plane/2009-11-043/A/FW13/
200
214
PLAYING
WITH THE
TOY
BATTERIES
GETTING
STARTED
TO REPLACE REMOTE CONTROL BATTERIES
Use a Phillips/cross head screwdriver
(not included) to loosen screw in battery
compartment cover (screw remains attached
to cover). Remove cover. Remove and discard
old batteries. Replace with 2 x 1.5V “AA” or R6
size batteries. Alkaline batteries recommended.
Replace cover and tighten screw.
TO INSTALL PLANE BATTERIES
Use a Phillips/cross head
screwdriver (not included)
to loosen screw in battery
compartment cover (screw
remains attached to cover).
Remove cover. Insert 3
x 1.5V “AA” or R6 size
batteries. Alkaline batteries
recommended. Replace cover
and tighten screw.
The plane’s ON/OFF switch is
located on the back of the
plane. Turn on the plane by
moving the switch to the
“ON” position.
IMPORTANT: BATTERY INFORMATION
CAUTION:
1. Always follow the instructions carefully. Use only batteries specified
and be sure to insert them correctly by matching the + and – polarity
markings.
2. Do not mix old batteries and new batteries or standard (carbon-zinc)
with alkaline batteries.
3. Remove exhausted or dead batteries from the product.
4. Remove batteries if product is not to be played with for a long time.
5. Do not short-circuit the supply terminals.
6. Should this product cause, or be affected by, local electrical
interference, move it away from other electrical equipment. Reset
(switching off and back on again or removing and re-inserting
batteries) if necessary.
7. RECHARGEABLE BATTERIES: Do not mix these with any other types of
batteries. Always remove from the product before recharging. Recharge
batteries under adult supervision. DO NOT RECHARGE OTHER TYPES OF
BATTERIES.
TIP FOR PARENTS:
To turn off sound effects in PLAY
mode, press and hold the middle button for 10 seconds or until
you hear a tone. Repeat step to turn the sound on again.
NOTE:
The LED light indicates that the plane is turned on. The plane
uses battery power whenever the switch is in the “ON” position. To help
conserve battery life, move the switch to “OFF” when you are not playing
with the toy.
Press button for
more sounds
Press button to move
plane forward
Press button to
turn plane
id_94819_MLP_Plane.indd 3-4
04/11/2009 9:30 AM
