Prior to assembly, insert batteries
(see directions at left).
First, snap two base pieces (A1, A2) together,
and press logo piece (A3) into place.
Press tree pieces together, then press
tree into place. Press drink stand and
signs into place as shown.
TO ASSEMBLE
A1
A3
A2
IMPORTANT: BATTERY INFORMATION
Please retain this information for future reference.
Batteries should be replaced by an adult.
CAUTION:
1. Always follow the instructions carefully. Use only batteries
specified and be sure to insert them correctly by matching the +
and – polarity markings.
2. Do not mix old batteries and new batteries, or standard (carbon-
zinc) with alkaline batteries.
3. Remove exhausted or dead batteries from the product.
4. Remove batteries if product is not to be played with for a
long time.
5. Do not short-circuit the supply terminals.
6. Should this product cause, or be affected by, local electrical
interference, move it away from other electrical equipment.
Reset (switching off and back on again or removing and
reinserting batteries) if necessary.
7. RECHARGEABLE BATTERIES: Do not mix these with any other
types of battery. Always remove from the product before
recharging. Recharge batteries under adult supervision. DO NOT
RECHARGE OTHER TYPES OF BATTERIES.
CAUTION: TO AVOID BATTERY LEAKAGE
1. Be sure to insert the batteries correctly and
always follow the toy and battery manufacturers’
instructions;
2. Do not mix old and new batteries or alkaline,
standard (carbon-zinc) or rechargeable
(nickel-cadmium) batteries;
3. Always remove weak or dead batteries from
the product.
Open storage door in the
mountain (A4) to locate the screw
in the battery compartment
door. Use a Phillips screwdriver
(not included) to loosen screw
(screw remains attached to door).
Remove door and insert 2 x fresh
1.5V “AA” or R6 size batteries.
Alkaline batteries recommended.
Replace door and tighten screw.
TO INSERT BATTERIES
A4
Snap mountain (A4) into
place.
Next, set butterfly ride into
place on top of mountain as
shown. Hook wing clips onto
antennas.
Place rainbow arch (C1) and waterfall
(C2) into place as shown. Snap
heart-shaped cutout (C3) over the
heart-shaped button located on the
top of mountain. Press canopy
onto mountain.
Assemble souvenir stand by
pressing both poles into cover
as shown. Press sign onto
cover, then press assembled
stand onto platform.
C2
C1
C3
