Harwin M80-940 Series Assembly Instructions Download Page 2

Page: 2 / 3

IS-26 Issue: 2 Date: 03.10.07 C/Note: 9874

Page 2 of 3

If added strain relief is required, fit a cable tie around the wires and through the cable tie

slots in the rear channel of the hood moulding:

Pull the cable tie tight, and then cut off any excess with suitable cutters:

Summary of Contents for M80-940 Series

Page 1: ...et IS 25 for instructions on using Datamate Assembly Tool Z80 280 The completed assembly will resemble this 2 Place the assembled connector into one half of the cable hood both halves are identical an...

Page 2: ...874 Page 2 of 3 3 If added strain relief is required fit a cable tie around the wires and through the cable tie slots in the rear channel of the hood moulding 4 Pull the cable tie tight and then cut o...

Page 3: ...f 3 5 Fit the second Cable Hood moulding Use a No 1 Pozidriv screwdriver to assemble the two retaining screws one in each side of the hood Tighten the retaining screws to a torque of 18Ncm DO NOT OVER...