HARVEY JIB MP250QM, Instruction Manual

Page: 11 / 39

10
— Loosen the star shaped screw on the guiding plate.
— Adjust the guiding plate to the numerical value of the machine workpiece width.
— Retighten the star screw tightly.
Press the operating lever to close the drive of the thicknesser feed roller, push the
operating lever downwards to ensure that it is in the separation position.
7.1.4 Planning flat workpiece
Place the flat workpiece on the planer table,
raise the shaft cover plate to the appropriate
height and start the machine. Press and move the
workpiece over the cutter body, hands move
above the cover plate, the material is moved by
the arm instead of the body! You must not move
the machine workpiece over the cutter body in
the opposite direction.
7.1.5 Planning high workpiece
When processing the high workpiece,
adjust the cutter cover plate to make the gap
between the workpiece and the machine is 5mm
at most. Start the machine and press the
workpiece move between the guide plate and the
cover plate over the cutter body.
7.1.6 Planning the workpiece with tilting
angle
Try to adjust the tilting angle (ensure the
90°position) of the guide plate by loosening the
fixed lever, tighten the handle and start the
machine. Press the slope processing workpiece
onto the guide plate and push forward.
7.1.7 Planning short worpiece
When planning a short workpiece, you need to use a push plate.