HARVEY COMPASS ST-1500, Operation Manual, Page: 13 / 28

12
10.3 Positioning the flip stop ( Fig. 22 )
The flip stop assembly can be moved to left or
right by loosening the locking knob (F1) and
positioned by reading the location of the indicator
(F2). After tightening the flip stop assembly, you
can micro-adjust the position of the flip stop
(±3mm / 1/8”). By loosening the knob (F3) and
rotating the knob (F4), you can micro-adjust the
flip stop to left or right.
The miter gauge is available in metric and
imperial versions, the version information can be
identified by the sign on the side of package box.
For metric version, the increment of a full turn of
the micro-adjustment knob is 1mm, and the
increment for each turn of one grid in the scale
ring is 0.02mm; for imperial version, the increment
of a full turn of the micro-adjustment knob is 1/20”,
and the increment for each turn of one grid in the
scale ring is 0.001”.
Fig.22
10.4 Unlocking the Sliding Table
Pull out the lock knob underneath the sliding table
and rotate it by 90° to unlock the sliding table.
When the sliding table is not in use, it should be
locked to prevent accidents.
11. Maintenance
Daily Check:

Loose mounting T-bolts or lock knobs.

Worn table saw switch.

Worn or damaged cords and plugs.

Any other conditions that could hamper the
safe operation of this sliding table
attachment.
Cleaning & Protecting:
Frequently blow-off sawdust with compressed air,
then wipe away the dust with a clean shop rag.
This is especially important for the internal
working parts of the sliding table assembly and
fence.