Propeller Owner’s Manual
147
MAINTENANCE PRACTICES
61-00-47
Page 6-5
Rev. 17 Sep/20
(6) Using clean potable water at low pressure, rinse the
surfaces where the soap solution was applied to remove
dirt, unwanted material, and soap residue.
(7) Use a clean dry cloth to dry the surfaces cleaned in the
previous steps.
(8) Rotate the propeller so that the next two blade(s) to be
cleaned are pointing downward, then repeat steps (5)
thru (7).
(a) Repeat steps (5) thru (8) until all blades have been
cleaned and dried.
(9) Let the propeller dry.
(10) Install the spinner dome in accordance with the
Installation and Removal chapter in this manual.
B. Spinner Cleaning and Polishing
(1) Clean the spinner using the General Cleaning
procedures in this section.
(2) If an aluminum spinner is dome is installed, polish the
dome (if required) with an automotive-type aluminum
polish.
