HARTING MICA RF-R300, Setup Manual, Page: 10 / 12

HARTING MICA
®
RF-R300 Complete RFID Starter Kit - Setup Guide
10
The antenna switch has three stages.
On, Antenna detect, and Off.
Set both switches to the ON position (pictured to the left).
Hit the plus button to increase the power to 500 mW.
By clicking “Start Inventory”, the reader will begin searching for tags. Hold an
RFID tag near the antenna and you will notice the Transponder ID, and RSSI (re-
ceived signal strength indicator) appear on the bottom of your screen.
It is very important to make sure the middleware app is turned off before changing any
settings on this page. If not you may receive the error message below.
The “log” page within Settings section of the “Management” page is used to edit the
settings for the log produced at the bottom of the “Apps” page.