Harris RF-7800W-OU49 series, Installation & Operation Manual

Page: 63 / 87

3-32
RF-7800W
SYSTEM ADMINISTRATION AND CONFIGURATION
R
3.10.3 Spectrum Sweep
The radio comes with the ability to survey the area for potential sources of interference, including weather radar,
Wi-Fi devices, high voltage power distribution, or other high-power radios. See
Figure 3-17 .
3.10.4 Network
The radio contains some network test and troubleshooting commands. The arp table can be viewed, edited and
cleared. Administrators also have the ability to ping a remote IP destination for network connectivity
troubleshooting.
3.10.5 Firmware Upgrade
See Figure 3-18 . The radio can be upgraded with new software that is posted to the Harris Premier site
(https://rfcommpremier.harris.com) . The upgrade files can be delivered to the radio via initiated FTP or TFTP
transactions, or directly via the GUI. The radio contains enough memory to store two versions of software. When a
new version is uploaded, it overwrites the inactive version. In order to complete the upgrade process, the radio must
be switched to the new, alternate version. Upgrade success and failure SNMP traps can be generated by the radio to
notify network administrators of the event.
NOTE
For example, version 3.0 may be the active version and you
may want to upgrade (downgrade) to version 2.0 which may
be loaded in the inactive version.
Figure 3-17. Spectrum Sweep
GUI
CLI
GUI CLI SNMP