Operation
OTM-20 Installation and Operation Handbook
3-13
Figure 3-20. Calibration Failure
Scale
In the Power Meter menu, press
[
]
to select Scale. Press
ENTER
to enter the
Scale Configuration, as shown in
Figure 3-21
. The four Scale selections are:
±
0.5 dB,
±
1.0 dB,
±
1.5 dB, and
±
2.0 dB. Press
[
]
to select a different scale and press
the
ENTER
button
to accept the selection. “*” indicates the selected menu item. Once
the scale is changed, the scale displayed on the screen will change immediately. After
the configuration is selected, press
QUIT
to back out to the higher-level menu. The
selections are not saved to memory and return back to the default value after the unit is
powered off.
Figure 3-21. Scale Configuration
Laser Source
Under the GUI, press
SET
to enter the Main menu. Use
[
]
to scroll through the
menu and highlight Laser Source. Press
ENTER
to enter the Laser Source menu, as
shown in
Figure 3-22
. After configuration is established, press the
QUIT
button
to
exit to the Main menu.
Summary of Contents for OTM-20
Page 5: ...OTM 20 Installation and Operation Handbook Figure 2 WEEE Compliance Symbol...
Page 6: ...OTM 20 Installation and Operation Handbook Blank Page...
Page 10: ...Contents OTM 20 Installation and Operation Handbook iv Blank Page...
Page 44: ...Data Collection Software OTM 20 Installation and Operation Handbook 4 8 Blank Page...
