12
DVSD / DVSE6800
+
Installation and Operation Manual
Chapter 2: Installation
Setting Jumpers
The DVSE6800
+
module has three standard jumpers; the DVSD6800
+
has one standard jumper. (The DVSD6800
+
only uses the P1 jumper
set.) Follow this procedure to set the
jumper for the proper signal:
1. Locate jumper sets on the module.
shows the standard
location of the P1, P2, and P3 jumper sets.
Figure 2-1.
Location of the Jumper Sets
2. Place a jumper on the P1 pin that corresponds to the setting that you
want. See
Figure 2-2.
P1 Jumper Set Settings
See
for more information about P1
jumper set settings.
Note
You need to configure modules
for local or remote operation
before
power-up. To change the
configuration, first remove
power from the module, reset
the jumper, and then reapply
power.
