Harper Verti-Cutter VC-60, Operator'S Manual

Page: 10 / 44

VERTI-CUTTER
R
R
• The machine should be operated on
levelsurfaces only.
• Before starting the machine, visually
inspect all nuts, bolts and other fasten-
ers to see that they are properly
secured. Nuts, bolts and other fasten-
ers should be checked every 8 to 10
hours of operation for proper align-
ment and tightness.
Operation
• Make certain the blades are clear of
debris before starting the machine.
• If a foreign object should strike the
blades of the machine and cause
an unusual noise or vibration, shut
the engine or PTO off immediately
and allow it to come to a complete
stop. Disconnect the spark plug wire
from the spark plug, or PTO from the
power unit, and then do the following:
1. Inspect for damage.
2. Repair or replace any damaged
parts.
3. Check for and tighten any loose
bolts, nuts, fasteners or parts.
• Keep debris or foreign material from
building up in the mower, as this may
inhibit proper operation or cause poor
performance.
• Keep all safety shields and guards in
place and in good working condition.
• Keep your face and all body parts
awayfrom moving parts.
• Stay away from the discharge area
when machine is in operation.
• If the vertical mower should become
clogged, shut off the engine or PTO
and allow it to come to a complete
stop. Disconnect the spark plug wire
from the spark plug or PTO shaft be-
fore clearing debris.
• Do not allow hands, clothing or any
part of the body to enter near any
moving parts.
• Replace damaged or missing safety
decals.
• Keep hands, feet and clothing away
from PTO driven parts.
• Keep all guards and shields in place
during operation. Disengage PTO and
shut off the engine before removing
guards or shields.
• Never attempt to adjust, clean or lubri-
cate the machine while PTO is con-
nected to tractor.
• Operator should never wear loose
clothing when working around PTO.
• Before starting tractor, make sure that
the transmission and PTO are disen-
gaged.
• Make sure the tractor’s engine is at
idle speed before engaging the PTO.
Transport
• Always use the ram stop when towing
the Verti-Cutter.
• SPEEDS SHOULD NOT EXCEED 10
MPH FOR MORE THAN 2 MINUTES
WHEN TOWING VERTI-CUTTER.
• The Verti-Cutter should be transported
on a trailer when moving distances
greater than 2 miles.
6 7