Harper DB1800
10
•
Keep the engine area free of oil, debris
and other accumulations.
•
Keep all safety shields and guards in
place and in good working condition.
•
Be sure to provide adequate
ventilation if the engine must be run
indoors – exhaust fumes are very
dangerous.
•
Periodically clean area around engine
to lessen the possibility of fire.
•
Engine governor settings are preset
and should not be altered. Any
change can damage moving parts and
void warranty.
Battery
SAFETY WARNING!
Observe all safety warnings printed on
the battery. Keep away from children.
•
Ventilate when charging battery or
using in an enclosed space.
•
DO NOT produce sparks from cable
clamps, tools, or other sources; and
DO NOT allow flames or smoking in
the vicinity of the battery.
•
Always wear safety glasses and
gloves when working with acid or near
the battery.
SAFETY WARNING!
Accidental engine starts can cause
severe injury or death. Before working
on the engine or equipment, disable
the engine as follows:
•
Disconnect the spark plug wires.
•
Disconnect the negative (-) battery
cable from battery.
SAFETY WARNING!
Do not leave machine unattended, or
attempt service or inspection unless
the machine has come to a complete
stop, the engine is off, and the Master
Disconnect is turned off.
SAFETY WARNING!
Contact your local Goossen Dealer or
Harper Industries for assistance if any
part of this manual requires further
explanation. Your safety and the
performance of the Debris Blower may
depend on a clear understanding of the
material contained in this manual.
For technical assistance or additional
information contact:
Harper Industries, Inc.
151 E. Highway 160
Harper, Kansas 67058
Tel. 1-800-835-1042
Or, visit our website at:
www.harperindustries.com
•
Before initial operation, fill the battery
with acid and connect the battery
cables. Unit is shipped without acid
and with cables disconnected.
•
Open vent on fuel tank. The engine
will run briefly even if vent is closed.
•
Place the control cable onto the tow
vehicle. Be careful not to drag cable.
SAFETY WARNING!
Use protective gear such as gloves
and safety glasses when servicing unit.
Set - Up
