Harol TR850, Assembly Instructions Manual

Page: 6 / 16

- 6 - V3-10-10
Assembly instructions terrace awning TR850
runner. The conical side of the wheel should be on the outside (fig. 10).
Then insert the guide rails in the cover, along with the runners. To do this,
the casing must be tilted slightly on its fixing hinge.
Make sure that the cable runs directly from the cable reel into the open-
ing in the guide rail provided for it (fig 1). Draw the cable taut to ensure
this is the case.
Then insert the end of the cable under the small pulley so that it bears
completely on the innermost pulley.
While doing this, hold the other cover in the same position as the first to
avoid excessive twisting of the casing (fig 9). Then insert the second guide
rail into the cover. Make sure the rail fits properly against the back of the
cover.
IMPORTANT: In areas close to the sea or
in locations liable to severe corrosion, it
is recommended that the sawn edges of
all rails are covered with transparent sili-
cone cement. This will guarantee better
resistance to attack by the elements.
Re-fit the stop pieces in the slot in the
guide rail so that the runner can no
longer be pulled out of the rail. Drill
a hole through the guide rail in(to) the pin of the cover in the position
indicated and fix the cover with a parker screw (fig. 7).
Now remove from the packaging the guide rails for the vertical section.
The end which is cut off square forms the lower end.
Then fix the ground plates to the rails by means of two M10 screws.
Now insert the end of the cable through the guide rail from the top.
The cable must exit through a hole drilled in the back of the guide rail (fig. 13A).
Open the sliding cover for this using a socket wrench. Pull the cable
through the opening as far as possible, then insert the end back through
the guide rail towards the front (fig. 13B), beneath the pulley. Pull the
cable out fully.
Position the vertical supports so that the track for the runners is towards
the front. The corner piece fixing hole will then be on the inside. Then fix
a small plate in the slot.
The 10,5 mm hole in the strip must correspond with the 10,5 mm hole in
the guide rail (fig. 14).
If further connections to other rails are necessary, the necessary strips
must be provided here as well.
Position the two base supports in their places directly in front of the hori-
zontal guide rails, which should by lying on the ground.
fig. 11
fig. 12
fig. 13
fig. 14