InstallatIon and operatIon Manual for WInd and sun screen sl400
09/12
|
5
4. InsTallaTIon sTePs
4.1. Checking and opening the packaging
first check the packaging for any external damage. next open the cardboard packaging.
Be careful when cutting the straps with a knife. careless opening of the box may result in
damage to the paint. It is recommended to remove the plastic film only from the ends. the
plastic provides good protection during installation.
4.2. Checking the contents
the SL400 is delivered ready for installation and includes the required screws. check the
contents of the package and check that the box has been painted in the requested colour.
check also that the supporting system is present, together with the guarantee card and
the table with tensile forces on screws. Screws for installation on the existing mounting
surface are not included.
4.3. Checking the dimensions
Measure the length of the box of the SL400. this should be 50 mm smaller than the specified
ordered length! the drop can only be checked after the screen has been mounted.
4.4. fabric opening left or right
left
right
Before starting with the installation, check that the fabric
opening is facing the correct side as specified in the order. If
upon closer inspection you decide that you want the other
fabric opening, then this can only be done on-site with the
straight fabric configuration.
changing the fabric opening must always be carried out with the
screen closed, and the 3 steps below must be closely followed.
1.
unscrew the suspension bracket from the housing or box, rotate the suspension
bracket 180° and then reinstall it in the same place using the nut and bolt.
